The printer does not extrude! What to do?

Probably there is still never happened, but the printer may, despite the presence of the wire stop extrude.
Don't worry, most likely is just the filament is clogged or plugged in the extruder.
In most cases, it helps ensure that the extruder is at a temperature of at least 200° c, if so you can proceed by portraying the thread for a few centimetres, and trying again.
If it doesn't go back, there are manuals guides on how to remove the residues of filament and how to replace a corked extruder with that emergency.

Related post

No results found

Menu