Layer sticking out? – Digital Editing Layer

If systematically every few layers, they are printed one protruding, can be resolved by performing the following steps:

We go under the "connect" button and select the "Terminal" tab. Then we go into manual control and type in the box and press "Send" GCode "M501". Row will appear in the Terminal; Locate the line that starts for M92 X ... Y ... Z. ... The pinand put it in the value next to the letter "Z." now we go to Configure-> Advanced > Slicer-and in the "Optimize" Step box "we write Z movements/mm" the value you've marked and tick on "Active Layer" Digitization.

Once this is done, try to reprint the piece.

Related post

No results found

Menu