Machine parameters reset

In case it is necessary to restore the internal parameters of the printer, first note the current values.

Go to the terminal and from the manual control launch the G-Code command “M501”

Parameters and commands will appear in the terminal as in the table below, at this point we proceed with:

mark all the values that have just appeared and keep them
from the manual control, launch the G-Code command “M502”, which will reset the printer parameters
re-enter the previously stored parameters

then in G-Code, in manual control, the previously stored commands must be re-launched separately, checking that the values are correct, in this case:

M92 X… Y… Z…
M203 X… Y… Z… E…
M201 X… Y… Z… E…
M204 P… R… T…
M205 S… T… B… X… Z… E…
M206 X… Y… Z…
M801 S…
M805 S…
M810 X… Y… Z…
M301 P… I… D… C…

Finally, type “M500” to register the entered parameters.